SERVICE
Closed-loop FFKM regeneration service
In closed-loop recycling, a manufacturer's own material is regenerated and goes back into the same production. Fanilo provides this as a service for FFKM: the customer sends FFKM, and receives the same material back. The service is engineered to match the quality of virgin material.
01 / SCOPE
What the closed loop covers
Both routes end in the same place: the FFKM returns to the company that made it.
ROUTE A
Production scrap
Moulding flash and rejected parts from your own FFKM production.
ROUTE B
Used parts returned by your customers
FFKM seals you supplied to a fab come back to you after use, and you send them on to Fanilo. The regenerated material returns to you.
02 / PRINCIPLES
Service principles
FFKM only
We specialise in regeneration technology for FFKM.
Returned as received
The material you send is the material you receive. Each lot is regenerated on its own and returned to you.
Original formulation kept
We do not change the customer's formulation. Colour and transparency are preserved.
Co-development
For requirements outside the standard service, our R&D team can develop a process together with the customer.
03 / THE RULES
What comes in is what goes back
Our service rests on one promise: you receive your own material, as you sent it. A few simple rules keep that promise.
One colour in, the same colour out
Send a single colour and you receive that colour.
Clear stays clear
Send clear FFKM and it comes back clear.
Mixed colours return as one lot
Colours sent together are regenerated together and returned as a single mixed lot.
Clean scrap only
Please send FFKM scrap free of tape and other foreign matter. Lots that contain them are returned unprocessed, and a handling fee applies.
Regeneration as a service
The material remains yours from receipt to return. We add nothing and change nothing.
04 / HOW IT WORKS
How it works
The steps below are the general flow. Details are agreed with each customer.
01
Enquiry
Contact us with the material type and the amount of scrap.
02
Trial batch
Send a sample of scrap. We regenerate it and return it for your evaluation.
03
Regular lots
Scrap is shipped to Fanilo lot by lot and regenerated with the agreed process settings.
04
Return
The regenerated FFKM is shipped back as PERFLUVIA™ for reuse in your production.
≥ 90%
Minimum share of scrap returned as usable material
≤ 30 days
Turnaround, worldwide*
*Actual lead time depends on capacity.
05 / BENEFITS
Benefits for the customer
Resource efficiency
Scrap goes back into production instead of being disposed of, so less new material is needed.
Material integrity
The process uses no chemicals and no heat. The original formulation, colour and transparency are kept.
Less waste
Less FFKM is sent for disposal, and less new raw material is consumed.
Lower material cost
Regenerated FFKM replaces part of the new material purchased.
Send us a sample of your FFKM scrap and we will run a trial batch.
info@fanilorubber.com
+886 3 530 1388